Vandy Vape Pyro V2 RDTA

I like the way this tank looks. The coil cutting jig is really nice for postless decks like this has.
This comes with a squonk 510 pin, but I don't sqonk so I replaced it with the included solid 510. That is problem 1, the solid 510 pin is a two piece thing, you screw the long part into the tank then add a short screw to complete it. Very weird and not the best on holding a resistance reading.
Once it is assembled, I put two plain clapton coils that should be 0.24 for the pair, wicked it, primed and filled the REALLY small tank.
Put it on a Triade 250C, it read at 0.30 ohms, incorrect. Twist it a little off/on, resistance read 0.14 ohms.
Get a different mod, a 75C and it was consistent, 0.30 ohms.
After playing with an identical tank and finding about the same readings, I replaced both sets of coils and had nearly the same results.
Put the mod on EScribe and ran the Atomizer Analyser. After a while, I found that tightening the tank down to where I thought it would break got a stable resistance reading of 0.235 ohms. Vapes great in Replay mode that way.
Do I really want to have to connect the mod to EScribe every time I change tanks? Nope.
You'll have to take the tank off the mod if you are not a squonker as the top is VERY hard to get off to fill the tank with a bottle. No way I'm going to pull that hard with it connected to my mod, I might loosen the 510 connector.
In all, maybe if you are a squonker it could be a nice tank.
The sheer hell the solid 510 pin introduces makes this something that will sit on a shelf for me though. Too hard to fill, too little juice in the tank, too finicky on getting the resistance to read properly.
A shame, because it does have smooth air flow and great taste when it is all working properly.

The rubber grommets make pulling the top off and on SO much easier than v1. I actually use a blunt tip to fill the v1 because it can be a nightmare to get the 2nd part with the fill holes off, which can slowly shred one of the orings. The v2 is buttery smooth. Airflow can be whatever you want. Postless deck is awesome, even moreso with the plastic tool for cutting coil legs to exact size. Came with two top notch Claptons which is rare. They come to .17-.19 using it as dual. I don't squonk, but didn't change the pin to the regular 510. Still no leaks at all. I love the Pyro v1 despite minor issues and the v2 still a huge improvement. Air holes in chamber are upgraded, too. It's my best RDTA and I have over a dozen including RTA's. Best I've owned. I don't chase clouds, but you can with this for sure. And the flavor is 10/10. The drip tip does get pretty warm if you chain vape. Only downside. But I'm going to build a .3-.4 dual set up and that should help. I like to vape at 30W-40W range or lower. If on the fence, buy it. It's nearly perfect. Vandy Vape rocks.